Aqueous Blister Coatings
麻豆传媒社区 offers the best in new聽advanced aqueous polymeric blister聽coatings. Our聽value added聽productivity gains are derived from running聽clean, fast drying aqueous blister coatings.聽Whether you run in-line or off-line, running聽麻豆传媒社区ote Aqueous Blister Coatings will be to聽your advantage. Run in-line sheetfed litho or聽flexo for the ultimate advantages of聽productivity and speed. Service your聽customers with the advantages of in-line聽speed and fast delivery capability.
CORKOTE Blister Coatings Characteristics
- Excellent fiber tearing seals to聽recommended blister boards
- Positive heat seal response with energy applied through substrate
- Low VOC
- Good gloss at 45-55 points @ 60 degrees
- Good adhesion
- Good block resistance
- Good abrasion resistance
- FDA Compliance to 175.105, 176.170, 176.80 as needed
- Non-settling, does not require聽continuous agitation during use
- Low odor
FORMULATIONS OFFERED
All are low VOC, 42% solids, and aqueous polymeric based. All are designed to be applied in a one bump application to achieve effective, acceptable heat seal functionality under normal blister sealing conditions.
RECOMMENDED IN-LINE CORKOTE BLISTER 聽COATINGS
LITHO & FLEXO
CK-5791-26 is formulated for in-line litho wet trapping with coat weights of 0.50 lbs./MSF to 0.80 lbs./MSF(DRY).
CK-5791-26 is an aqueous , fast drying heat seal coating that has been formulated to provide effective fiber tearing properties for blister board card application. Usage: CORKOTE鈥� 5791-26 is specifically designed to be applied one bump, inline, wet trapped over conventional wax free sheetfed offset litho blister pack inks. It has also demonstrated functionality when applied in-line over blister pack flexo or sheetfed offset UV inks. It is heat sealable to a variety of blister cell plastic films. 聽Recommended single bump dry coat weight range is 0.50 lbs./MSF to 0.80 lbs./MSF(DRY).
These聽recommended single bump dry coat weights聽have been obtained using tower coaters and聽blanket coaters. Effective fiber tearing seals聽have been obtained when sealing PVC and聽other blister cells to recommended blister聽boards within standard heat sealing聽conditions of 350掳F-375掳F, 50-60 PSI, and 2-3 seconds dwell. Per usual, the longer聽temperature/pressure/time conditions are聽required when heavier pt. recommended聽blister board stocks are used.
CK-5791G is recommended for Flexo or Rotogravure Blister Applcation.
